Author Denali 2.0 CANsmart controller issue  (Read 1052 times)

0 Members and 1 Guest are viewing this topic.

  • Offline BravoMike   us

    • XR Member  ‐    18
    • **
    • Topic Author

    Offline BravoMike

    • XR Member
    • **
    • Topic Author
    • Posts: 18
    • Bike: 2021 S1000XR
    • Town: Indianapolis
    • Country: us
    Denali 2.0 CANsmart controller issue
    on: November 25, 2021, 07:30:49 am
    November 25, 2021, 07:30:49 am
    Hello all, I’ve been having an issue with my hexcan controlling my dual B6 brake lights. I have pasted the email I sent to HEXEZCAN below because I’m curious if anyone else have noticed the same behavior.

    I have a cansmart 2.0 connected to my 2021 S1000XR that is controlling dual B6 brake lights. I have purchased and installed these a week ago and have noticed an inconsistent issue with them. I have them setup as brake/running lights and flash 3 times when over speed 9mph when braking. Sometimes they work just fine and I’ve notice (or have been told by people behind me) that they start flashing constantly. The only way to stop this behavior is to turn the bike off then back on. Has this fault been noticed before and is there a fix to this?

  • Offline advr6   ca

    • XR Pro  ‐    113
    • ***
      #1

    Offline advr6

    • XR Pro
    • ***
    • Posts: 113
    • Bike: S1000XR
    • Town: Burlington
    • Country: ca
    Re: Denali 2.0 CANsmart controller issue
    Reply #1 on: November 25, 2021, 01:51:40 pm
    November 25, 2021, 01:51:40 pm
    It might be the controller itself.  My Gen 1 was replaced under warranty and the replacement Gen 2 as well, although my issue was with the front mounted DR1s working intermittently and not coming on unless dimmed to more than 50%.  I have the B6s as well but never noticed them misbehaving ...

     



    dysfunctional