OEM - top box fitting Instructions

[JohnnyGT]

  anyone got a instruction manual on how to fit the OEM top box on the back bracket.

May be a bit stupid question but what end goes in first, clip it then slide it forward. 🤣

[Gatsoburner]

Dont have a top box for the Gen2 model as yet, and didnt have a BMW one for the Gen1 either.

Usually, they slide towards the front of the bike into securing lugs and then snape down and lock below the key barrel area.

Without sounding an arse.... , is it not obvious as i'd guess there is only 1 way to secure it matching the fittings...?

[JohnnyGT]

Originally Posted by Gatsoburner

Dont have a top box for the Gen2 model as yet, and didnt have a BMW one for the Gen1 either.

Usually, they slide towards the front of the bike into securing lugs and then snape down and lock below the key barrel area.

Without sounding an arse.... , is it not obvious as i'd guess there is only 1 way to secure it matching the fittings...?

Yes (Gen 1) I got the slide forward part but then the "front" lugs seems to be hard to get in holes. Tried both ways and then it got dark and lightning was not helping, I'll try again as I may have misses the key lock area.

Cheers

[JohnnyGT]

  got it sorted after looking g again in daylight, unlock case,lift lever handle and mechanism moves the front lock clips setup.

Now just to setup the new key locks and she's good to go