Finally fitted the Innovv K3 Dash Cam to my Gen 1
This is not a step by step guide to fitment it just my impressions of the kit and where it is fitted to 'my' bike.
Before I commenced fitment I did look to see if there were any 'YouTube' tutorials regarding fitment to an XR - but - I could not find any specifically for our XR machines, so I had to go it alone and fathom out where the best place would be for my bike (in my opinion).
The kit it’s self if a quality bit of gadgetry and what it comes with will enable you to mount the kit without getting any additional parts. It does come with an 'installation fold out sheet' which again is straight forward to understand, take time to read it and it will certainly help.
You obviously have to be careful taking the various panels of the bike but that's no big deal if you have some common sense and the correct tools (which you don't need many of - tools that is)
Once I had the plan of where everything was going it was quite a straight forward installation and everything went well with the strip down and build up - (nothing scratched or broken!!)
The only bit of help I needed was to establish which wire I could use for the ACC power wire after Ignition, which I got the answer from this forum (many thanks for that)
It connected to the App on my iPhone easily and with a bit of time you can configure it to your liking.
Where I have mounted the cameras facilitates a 'full view' with nothing of the bike being an intrusion on the playback, even the top box when fitted is not evident in the rear view.
That's it - hope it was of interest to some of you guys & gals who might be thinking of getting one.
